Toro Multi Pro 41240 Operator's Manual page 86

4. Assemble the rate control valve, gasket, and
agitation-valve manifold with a flange clamp and
tighten by hand (Figure
5. Align a gasket between the flanges of the
agitation-valve manifold and the master-boom
valve (Figure 128A)
6. Assemble the agitation-valve manifold, gasket,
and master-boom valve with a flange clamp and
tighten by hand (Figure
7. Assemble the outlet fitting onto the coupling
fitting at the at the bottom of the manifold for the
agitation valve (Figure
8. Secure the outlet fitting to the coupling fitting by
inserting a retainer into the socket of the outlet
fitting (Figure 128B)
9. Assemble the agitation valve to the valve mount
with the flanged-head bolt and flanged locknut
(Figure 127) that you removed in step
Removing the Agitation Manifold Valve (page
79), and torque the nut and bolt to 10 to 12 N∙m
(90 to 110 in-lb).
10. If you loosened the mounting hardware for the
master-boom valve, tighten the nut and bolt to
10 to 12 N∙m (90 to 110 in-lb).
128A)
128A)
128B)
3 of
Installing the Master Boom
Manifold Valve
1. Align the flange of the master-boom-valve
manifold, a gasket, and the flange of the
master-boom bypass valve
1. Flange (agitation valve)
2. Flange
(bypass—master-boom
valve)
3. Manifold (master-boom
valve)
2. Assemble the master-boom valve manifold,
gasket, and master-boom bypass valve with a
flange clamp tightened hand tight
3. Align the flange of the master-boom-valve
manifold, a gasket, and the agitation-valve
manifold (Figure
4. Assemble the master-boom-valve manifold,
gasket, and agitation-valve manifold with a
flange clamp and tighten by hand
5. Align the socket of the 90° outlet fitting onto
the coupling fitting at the at the bottom of the
manifold for the master-boom valve
130).
86
(Figure 129).
Figure 129
4. Flange clamp
5. Gasket
6. 3-pin connector (valve
actuator—master-boom
valve)
(Figure
129).
(Figure
(Figure
g033590
129).
129)