Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Conditioner Reel Spring
Installation (Option)
NOTE
Refer to Conditioner Single Reel Installation shown in
See Figure 3-36.
for single reel installation.
1. Slide the adjustment pin through the rear plates of
center and wing frames, secure with (2) 2-1/2 snap
rings.
2. Assemble the 1-8 x 9 adj bolt through adjustment pin
on frame, 1" lock washer, (2) 1-8 hex nuts, and 17"
heavy spring assembly.
3. Install 1-1/2" flange bearing into reel arm. Slide in
1-1/2" pivot bushing.
4. Attach reel arm to upper hole on rear center or wing
frame or double mount using 1-8 x 6-1/2 hex head
cap screw and hex lock nut.
3-50
5. Assemble 17" heavy spring assembly to reel arm
using 1" pivot pin, and 5/16 x 1-1/2" spring slotted
pins. Set pin centers to 21" dimension as shown in
Figure 3-36.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, lift, pull hitch, or reel/gang bar
assembly manually. Use a hoist or a forklift to
move these parts into position.
6. Attach single reel/gang bar assembly to reel arms
using gang bar mount plate, 3/4-10 x 6 hex head cap
screws and double hex lock nuts as shown in
Figure
3-36..
(See "Conditioner Reel Placement
40' (LH)" on page 2-4.)
bar placement locations.
WARNING
thru 2-7 for single reel gang
F-987-0519
See
Advertisement
Chapters
Table of Contents
