Finishing Hydraulic Conditioner Reel Installation (Option) - Landoll VT Plus 7431 Operator's Manual

ASSEMBLY INSTRUCTIONS
Finishing Hydraulic Conditioner
Reel Installation (Option)
NOTES
Refer to Figure 3-26 for hydraulic diagram for the
7431-20 model.
Refer to Figure 3-27 for hydraulic diagram for the
7431-23 model.
Refer to Figure 3-28 for hydraulic diagram for the
7431-26 model.
Refer to Figure 3-29 for hydraulic diagram for the
7431-29 model.
Refer to Figure 3-30 for hydraulic diagram for the
7431-33 model.
Refer to Figures 2-1 - 2-12 for hose clamp locations.
1. Attach reel arm assemblies to rear frame in top hole
using 1-8 x 6-1/2 hex head cap screw, pivot bushing,
flange bearings, and hex lock nut (See Figure 3-32.)
for single reel or (See Figure 3-33.) for double reel.
BULKHEAD PLATE
2-1/2 - 8-1/2
HOSE CLAMP
OR
4-1/2 - 6-1/2
HOSE CLAMP
2 HOSE CLAMP
hyd cond reel hose clamps
Figure 3-31: Finishing Hydraulic Conditioner Reel Hose Clamp Installation (Option)
3-38
2. Attach 17" spring assembly and 2-1/2 hydraulic
cylinder to lower hole on rear frame using cylinder
trunnion, cylinder trunnion stop, 1/2-13 x 1-1/2 hex
head cap screw, and split lock washer.
NOTE
On 7431-33 models, center reel arm has regular spring
setup.
3. Install the manifold to the manifold bracket on the
frame using 1/2-13 x 3-1/2 hex head cap screws and
hex lock nuts.
4. Install fittings into manifold according to Figures 3-26
thru 3-30.
5. Install hoses per Figures 3-26 thru 3-30.
6. Install hose clamps onto frame (See Figures 3-31
and 3-34.)
7. Install steel plugs in any remaining open manifold or
valve ports.
8. Attach conditioner reel/gang bar assembly to reel
arm assemblies using gang bar mount plates, 3/4-10
x 6 hex head cap screws, and double hex lock nuts.
3/8-16 FLANGE
LOCK NUT
HOSE CLAMP
3/8-16 X 1-1/2
HEX HEAD
CAP SCREW
1/2-13 FLANGE
LOCK NUT
HOSE CLAMP
BRACKET
1/2-13 X 1-1/2
RD HEAD SQ
NECK SCREW
F-561-0818