Racelogic VBOX Touch User Manual page 57

How to Manually Set a Start/Finish Line
It is possible to manually set a start/finish line when
moving, overwriting the line detected within the circuit
layout.
To manually set a start/finish line, tap the screen within
the Basic Lap Timing Screen
within the Settings.
A screen will be displayed, allowing you to cancel the
start/finish line gate set within 5 seconds by repressing
the screen. After 5 seconds, you are required to drive
forward in a straight direction to complete the process.
The gate is set at 90° to the detected heading and the
width is dependent in what is selected within the
Width Settings.
The detected location when the screen is initially
pressed/start gate set is used as the centre point of
start/finish gate.
If you are defining a separate
act as the Start Line only.
Notes:
• The vehicle must be moving >0.8 km/h and the unit have satellite lock to set a Start/Finish Line.
• If start/finish line setting is cancelled, any live lap prediction for the current lap will be lost and unavailable for use.
or select Set Start Gate
Gate
Finish Line, this gate will
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_Touch/VBOX_Touch_User_Guide/04_-
New start/finish line cancellation screen
_VBOX_Touch_Display_Modes/VBOX_Touch_-_Lap_Timing_Mode
57