Table of Contents
Advertisement
CHAPTER 3: INSTALLATION
3.5
ADDING/REPLACING EPIMs
This section contains procedures on how to add or replace an Ethernet
Port Interface Module (EPIM) to upgrade or change the capabilities of
your SEHI. After installing a new EPIM, refer to the appropriate EPIM
section in Appendix A to verify proper operation.
Observe all static precautions while handling EPIMs.
!
CAUTION
To install an EPIM:
When removing an EPIM, pull the module straight out to
prevent damage to the connector.
NOTE
1. Remove the coverplate or the EPIM (whichever applies).
2. Slide the new EPIM into place, making sure that the connectors on the
rear of the EPIM align correctly and firmly with the connector inside
the SEHI. Refer to Figure 3-9.
3. Install the mounting screw.
3-10
Figure 3-9. Installing an EPIM
EPIM-2
EPIM-1
LNK
EPIM-T
1490_12
SEHI USER'S GUIDE
Hide quick links:
Advertisement
Table of Contents
