Stacking The Sehi - Cabletron Systems SEHI-22 User Manual

Figure 3-6. Installing the SEHI in the Rack
If the installation requires that the SEHI is to be stacked, proceed to
Section 3.3.5. Otherwise, continue by connecting power as described in
Section 3.4.

3.3.5 Stacking the SEHI

The rear panel of the SEHI has an Interconnect Bus Out Port (male
connector). Daisy chain units together using Cabletron Systems
HubSTACK Interconnect cables. Table 3-1 describes each cable.
Table 3-1. HubSTACK Interconnect Cables
Part
Number
9380110
9380111
To stack the SEHI together with an SEH non-intelligent hub:
1. Attach the SEHI HubSTACK Interconnect cable to the "OUT" port on
the rear panel of the SEHI as shown in Figure 3-7.
2. Attach the other end of the SEHI HubSTACK Interconnect cable to
the "IN" port on the rear panel of the SEH.
SEHI USER'S GUIDE
HubSTACK
10BASE-T HUB LANVIEW®
WITH
SEHI-24
Screws (4)
Description
12" HubSTACK
Interconnect Cable
18" HubSTACK
Interconnect Cable
19-Inch Rack
Application
SEH to SEH connections
SEHI to SEH connections
INSTALLING THE SEHI
1490_9
3-7