Connecting The Sehi To The Power Source - Cabletron Systems SEHI-22 User Manual

HubSTACK
SEH-24
HubSTACK
SEH-24
HubSTACK
SEHI-24
SEH INTERCONNECT OUT
Figure 3-8. Disconnecting the HubSTACK Interconnect Cable
Proceed to Section 3.4 to connect power.

3.4 CONNECTING THE SEHI TO THE POWER SOURCE

The SEHI has a universal power supply. This allows
connecting the SEHI to power sources from 100-125 and
NOTE
200-240 Vac, 50-60 Hz.
To connect the SEHI to the power source:
1. Plug the power cord into the back panel of the SEHI.
2. Plug the other end of the power cord into a grounded wall outlet.
3. Verify that the PWR LED is on, indicating that the SEHI is receiving
power. After the SEHI runs a self test, the CPU LED blinks green
indicating normal operation. If the LED remains red, the processor is
faulty; contact Cabletron Systems Technical Support.
SEHI USER'S GUIDE
CONNECTING THE SEHI TO THE POWER SOURCE
Disconnect SEH and SEHI Interconnect Cables
at the "OUT" Port.
10BASE-T HUB LANVIEW®
WITH
OUT IN
SEH INTERCONNECT
10BASE-T HUB LANVIEW®
WITH
OUT IN
SEH INTERCONNECT
10BASE-T HUB LANVIEW®
WITH
1490_11
3-9