Connecting A Thin-Net Segment To An Epim-C - Cabletron Systems SEHI-22 User Manual

4.1.4 Connecting a Thin-Net Segment to an EPIM-C

To connect a thin-net segment to an EPIM-C:
1. Set the Internal Termination switch, located to the right of the port and
labeled TERM to:
• The ON position (
the port will be internally terminated at the port.
• The OFF position (
terminated at the port or externally terminated.
2. If the Internal Termination switch is in the ON position, connect the
thin-net segment directly to the BNC port as shown in Figure 4-4.
3. If the Internal Termination switch is in the OFF position:
a. Attach a BNC tee-connector to the BNC port on the module.
b. Attach the thin-net segment to one of the female connectors on the
tee-connector.
Terminate each segment attached to the tee-connector. If a
NOTE
segment is not attached to one of the female connections on
the tee-connector, place a terminator on that connection.
c. Attach another thin-coax segment or a terminator to the other
female connector on the tee-connector.
SEHI USER'S GUIDE
CONNECTING THE SEHI TO THE NETWORK
•
) if the thin-net segment connected directly to
) if the thin-net segment will not be internally
o
4-7