Resetting The Smartswitch Remote Access Module; Accessing The Module - Cabletron Systems SmartSwitch 9W006 Quick Start Manual

inserts into
PRI port
For non-U.S. and European installations, standard cabling is sufficient (refer to following section).
M PRI S
ODULE TO ERVICE
PRI cabling is not included. You will need to determine the length of cable you need for your
connection. PRI cabling is straight-through twisted-pair cable with RJ-45 adapters at each end.
1. Insert the RJ-45 adapter at one end of the PRI cable into either the Mod-Tap adapter (U.S. and
Europe) or directly into the module's PRI port 1 (for all other installations).
2. Insert the RJ-45 adapter at the other end of the PRI cable into your PRI service drop.
3. Repeat steps 2 and 3 for PRI ports 2, 3, and 4 if applicable.
R S
ESETTING THE MART
The reset switch is a recessed switch located on the front panel, under the top-left plastic ejector tab.
The reset switch serves two functions:
1. Pressing the reset switch twice within three seconds causes the processor to reset.
2. Pressing and holding the switch on for three or more consecutive seconds causes the module
to shutdown. Pressing and holding the switch again for three seconds restarts the module.
SNMP management may be used to disable this switch to enhance module security.
A M
CCESSING THE
This section provides instructions for:
• accessing a SmartSwitch Remote Access Module for the first time
• remotely accessing the SmartSwitch Remote Access Module after the first time
Mod-Tap
Adapter
1
2
RJ-45
TX+ 3
Pinout
RX+ 4
RX-
5
TX- 6
7
8
C
ABLING
S R A
WITCH EMOTE
ODULE
insert one end of PRI cable here,
other end into PRI service drop
M
CCESS ODULE
I
NSTALLING THE

Accessing the Module

RX+
1
2 RX-
Adapter
3
RJ-45
TX+
4
5 TX-
Pinout
6
7
8
9W006 and 9W007
M
ODULE
11