Related Manuals for Cabletron Systems 9F426-03
Summary of Contents for Cabletron Systems 9F426-03
- Page 1 SmartSwitch 9000 9F426-03 Local Management Appendix 9032058-01...
-
Page 3: Module Interfaces
Introduction This appendix contains local management information that is specific to the 9F426-03 FDDI Switch Module. Module Interfaces The 9F426-03 FDDI Switch Module has 8 interfaces. Table 1 lists the identifying number, name, and description of each interface. Interface Number Table 1. - Page 4 9F426-03 Module Specific Information Use the numbers listed in Table 1 to configure the module’s default interface (see General Configuration Screen in the SmartSwitch 9000 Module Local Management User’s Guide ).
- Page 5 Module Name: 9F426-03 Slot Number: 11 FDDI Address: 00:00:B8:00:10:62 Current RingMap: FRONT PANEL 1 (isolated) 00:00:B8:00:10:62 (NAS) <<<<<<<<<<<<<<<<<<< [FRONT PANEL 1 (isolated)] 9F426-03 Module Specific Information SmartSwitch 9000 Local Management Ring Map Configuration Figure 1. Ring Map Configuration Screen Firmware Revision: 01.04.10 BOOTPROM Revision: 01.02.00...
- Page 6 9F426-03 Module Specific Information Ring Map Configuration Screen Fields The following information briefly explains each Ring Map Configuration Screen field. FDDI Address Displays the address of the module. The format of this address (either MAC or Canonical) is determined by the value you select in the Address Mode field.
- Page 7 Displaying the Ring Map Node Screen To display the Ring Map Node Screen (from the Ring Map Configuration Screen), use the arrow keys to highlight an address, then press the Return key. The Ring Map Node Screen appears. 9F426-03 Module Specific Information...
- Page 8 9F426-03 Module Specific Information Ring Map Node Screen The Ring Map Node Screen (Figure 2), displays specific information for a selected FDDI node on the Ring Map. Module Name: 9F426-03 Slot Number: 11 Address: Upstream Address: Node Class: Mac Count:...
- Page 9 9F426-03 Module Specific Information Ring Map Node Screen Fields The following information briefly explains each Ring Map Node Screen field. Address Displays the address of the selected node. Upstream Address Displays the address of the selected node’s nearest upstream neighbor.
-
Page 10: Switch Configuration Screen
9F426-03 Module Specific Information Switch Configuration Screen The Switch Configuration Screen (Figure 3), displays parameters you can configure to make the switch operational. Module Name: 9F426-03 Slot Number: 9 Switch Address: Numbers of Ports: Port # SAVE Port # refers to the following: NOTE •... - Page 11 This interface will not forward any traffic through the bridge. Status (Toggle) Allows you to set the forwarding status of the listed interface. Press the Space Bar to toggle to the desired value. Valid values are: • ENABLED ( default ) • DISABLED 9F426-03 Module Specific Information...
-
Page 12: Full Duplex Configuration Screen
9F426-03 Module Specific Information Full Duplex Configuration Screen The Full Duplex Configuration Screen (Figure 4), allows you to specify transmit and receive settings for the module’s front panel ports. Module Name: 9F426-03 Slot Number: 9 PORT# SAVE SmartSwitch 9000 Local Management... - Page 13 • DISABLED - The port is turned off administratively. SET ALL PORTS (Toggle) Allows you to set all the FDDI ports to either FULL DUPLEX or STANDARD FDDI at one time. • FULL (default) • STANDARD 9F426-03 Module Specific Information...
- Page 14 9F426-03 Module Specific Information...
Need help?
Do you have a question about the 9F426-03 and is the answer not in the manual?
Questions and answers