Installing And Launching Sfvra-Cfg - Cabletron Systems SmartSwitch 9W006 Quick Start Manual

QUICK START
Note: Do NOT place more than one SmartSwitch Remote Access Module on a LAN with the
default IP address. If more than one module has the same IP address, unpredictable results
will occur.
After you make a Telnet connection, enter your login ID and password. Then you will be presented
with a system prompt and you can enter commands at that time.
U S
PGRADING OFTWARE
Perform the steps below to upgrade the module's system software:
1. Insert the 9W006/9W007 Remote Access Module CD-ROM into the PC.
2. Using the PC,
3. Once you have an administration session (you have logged in to the module) enter the special
Manage Mode by typing the following command at the system prompt:
>manage
Note: Once Manage Mode is entered, the prompt changes from [system name]> to
[system name]:MANAGE>.
4. Change the TFTP configuration by typing tftp change . The following messages will be
displayed:
Current TFTP Configuration:
The TFTP Feature is enabled.
The TFTP Client is enabled.
The TFTP Server is disabled.
You will be prompted to change the status for each configuration element. Enable the TFTP
Server and assign file access rights to Admin.
5. Use a TFTP client application to PUT the UPGRADE.OSW file from the 9W006/9W007 Remote
Access Module CD-ROM to the \SYSTEM directory on the module that you want to upgrade.
6. Return to the Telnet console and issue the exit Manage Mode command.
Note: You will receive a warning that the current configuration data has not been
permanently stored in the configuration files. Do NOT save the TFTP configuration
changes.
7. Issue the restart console command to complete the Upgrade process.
I L
NSTALLING AND
SFVRA-CFG allows you to centrally configure and manage a network that includes SmartSwitch
Remote Access Modules and CyberSWITCH systems. It is made up of two main components: the
14 SmartSwitch Remote Access Module
Telnet to the module.
SFVRA-CFG
AUNCHING