Assembling The Cord End Terminal And The Power Cable - Huawei AP7052DN Hardware Installation And Maintenance Manual

AP7052DN&AP7152DN
Hardware Installation and Maintenance Guide
Step 3 Put the bare crimping terminal onto the exposed conductor, and ensure that the bare crimping
terminal is in good contact with the insulation of the power cable, as shown in Figure 5-29.
Step 4 Crimp the joint parts of the bare crimping terminal and the conductor, as shown in Figure
5-30.
Figure 5-30 Crimping the joint parts of the bare crimping terminal and the conductor (JG
terminal)
Step 5 Push the heat shrink tubing toward the connector until the tube covers the crimped part, and
then use a heat gun to heat the tube, as shown in Figure 5-31.
Figure 5-31 Heating the heat shrink tubing (JG terminal)
----End

5.1.2.5 Assembling the Cord End Terminal and the Power Cable

Context
Figure 5-32 shows the components of a cord end terminal and a power cable.
Issue 01 (2017-12-29) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Appendix
53