Installing The Cord End Terminal - Huawei AP7052DN Hardware Installation And Maintenance Manual

AP7052DN&AP7152DN
Hardware Installation and Maintenance Guide
If the two terminals are different sizes, place the smaller one above the bigger one. A
maximum of two terminals can be installed on a post.

----End

5.1.5.2.2 Installing the Cord End Terminal

Procedure
Step 1 Hold a cord end terminal upright and place it on a terminal jack, as shown in Figure 5-114. To
ensure bump contact and dense connection, place the plain side of the terminal outwards.
Figure 5-114 Placing a terminal on a terminal jack vertically
Step 2 Insert the terminal into the jack vertically, and turn the screw clockwise to fasten the terminal,
as shown in Figure 5-115.
Issue 01 (2017-12-29)
Figure 5-113 Crossing two terminals
To remove an OT terminal, loosen the screw counterclockwise.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Appendix
98