Huawei AP7052DN Hardware Installation And Maintenance Manual page 35

AP7052DN&AP7152DN
Hardware Installation and Maintenance Guide
The following table lists the default configuration of the device. You are advised to change the
default user name and password on your first login.
Table 3-2 Default configuration of the device
Parameter
User name
Password
IP address
Subnet mask
SSID
Wireless password
The following example uses the default parameters and is used for reference only.
Wired Connection Mode
Step 1 Use a network cable to connect a PC to any network port of the AP or that of the switch on
the same network segment as the AP.
Step 2 Assign the PC with an IP address on the same network segment as the default IP address of
the device so that the PC and device are reachable to each other.
If the device uses the default settings, the IP address of the PC must be in the network
segment 169.254.0.0/16 but cannot be 169.254.1.1. 169.254.1.100 is recommended.
Step 3 Open the browser on the PC, enter http://IP address in the address box, and press Enter to
log in. Select a language for the web system, enter the default user name and password, and
click Login to enter the web system home page.
----End
Issue 01 (2017-12-29)
For a Fit AP and cloud AP, you can perform the following operations:

If the Fit AP in any version is offline or the Fit AP in V200R007C10 or later does not go online, you
can access the device through the offline management VAP for operations. By default, the SSID of
the offline management VAP is hw_manage_xxxx (xxxx specifies the last four bits of the AP's MAC
address) and the password is hw_manage. After the IP address of the PC is set to 169.254.2.x/24
(169.254.2.1 excluded and 169.254.2.100 recommended), the connection is set up, , and you can log
in to the AP using web system for operations.
 If the cloud AP is offline or does not go online, you can access the device through the offline
management VAP for operations. By default, the SSID of the offline management VAP is
hw_manage_xxxx (xxxx specifies the last four bits of the AP's MAC address) and the password is
hw_manage. After the PC dynamically obtains an IP address and connects to the AP, you can log in
to the AP using web system for operations.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Logging In to the Device
Default Setting
admin
admin@huawei.com
 Wired connection: 169.254.1.1
 Wireless connection: 192.168.1.1
 Wired connection: 255.255.0.0
 Wireless connection: 255.255.255.0
HUAWEI-XXXX, applicable to wireless
connections of Fat APs (XXXX specifies the
last four bits of the AP's MAC address.)
None, applicable to wireless connections of
Fat APs
28