Removing An Ap - Huawei AP7052DN Hardware Installation And Maintenance Manual

AP7052DN&AP7152DN
Hardware Installation and Maintenance Guide
Installing an AP in an Irremovable Ceiling
1.
2.
1. Ceiling tile
3.

2.6.5 Removing an AP

Flip the spring clip on the mounting bracket and slip the AP towards the spring clip. Release
the spring clip until the rubber feet of the AP enter the mounting keyholes. Remove the AP
from the mounting bracket.
Issue 01 (2017-12-29)
Draw the AP mounting position on the ceiling tile using an opening mold and cut an
opening.
Use clamp 1 to align with the dent of the opening on the ceiling tile and mark the two
holes in the middle of clamp 1. Drill two holes with a diameter of 5 mm on both sides of
the opening on the ceiling tile. Use four M4x30 screws to tighten clamps 1 and 2 to the
ceiling tile (with a tightening torque of 1.2 Nm).
2. Clamp 1
Install the mounting bracket, cables, AP, and enclosure. For details, see steps 2, 3, 4, and
5 in Installing an AP in a Removable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3. Clamp 2
Ceiling.
2 AP Installation
4. M4x30 screws
18