Installing The Ap; Installing The Device On A Wall - Huawei AP7052DN Hardware Installation And Maintenance Manual

AP7052DN&AP7152DN
Hardware Installation and Maintenance Guide

2.6 Installing the AP

2.6.1 Installing the Device on a Wall

Mounting kits and expansion bolts are required to install the AP on a wall. The procedures are
as follows:
When fixing the sheet metal mounting bracket, ensure that the arrows point upwards on the
1.
2.
3.
Issue 01 (2017-12-29)
A wall for installing the device needs to meet the following requirements:

The wall can bear the weight of four times the total weight of the device and mounting bracket
without damage.
When the tightening torx of a screw reaches 5 N•m, the screw still properly works, without crack or

damage on the wall.
label.
Fix a mounting bracket to the wall against the wall and mark the drilling positions
through holes of the bracket.
Use a 6 mm drill bit to drill 25 mm to 30 mm deep holes in the drilling positions.
Hammer the expansion tubes into the holes until the expansion tubes are completely
embedded into the wall.
Fix the mounting bracket to the wall and use the Phillips screwdriver to fasten three
expansion screws into the expansion tubes.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 AP Installation
12