Assembling Power Cables - Huawei AP8030DN Installation And Maintenance Manual

Huawei AP8030DN & AP8130DN
Hardware Installation and Maintenance Guide

5.1.2 Assembling Power Cables

Assembling the OT Terminal and Power Cable
Context
Figure 5-1
Figure 5-1 Components of an OT terminal and a power cable
A Heat-shrinkable tubing
Procedure
Step 1 Based on the cross-sectional area of the cable conductor, strip a length of insulation coating C
to expose the conductor D of length L1, as shown in
L1 are listed in
Issue 02 (2014-12-05)
– The terminals and conductors should be connected tightly after they are crimped. They
should not be moved or turned.
– Cut all the exposed copper wires.
– Try to avoid a second crimping of sleeves.
– Keep all the conductors clean and aligned.
NOTE
The connectors, cables, and tools provided by different vendors may be different. The figures in this
document are only for your reference.
shows the components of an OT terminal and a power cable.
Table 5-1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
B. Bare crimping terminal
Figure
5 Appendix
C. Insulation D. Conductor
5-2. The recommended values of
45