Help; Image - Cabletron Systems CSMIM2-16 Installation Manual

Chapter 3: ROM Monitor Commands
If the self-boot option is not installed, the command display looks
like this:
monitor:: erase
Erase all non-volatile EEPROM memory? (y/n) [n]:: y
Erasing <16352 or 8160 bytes> of non-volatile memory.
Please wait . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Initialized checksum record installed
The erase command does not erase the Ethernet address.
NOTE
Since the erase command erases the IP address, you must
use the addr command to re-enter the CSMIM2's IP address
before reloading any software.
3.2.6

help

Entering help, or ?, displays brief descriptions of the CSMIM2 ROM
Monitor commands.
3.2.7

image

The image command sets and displays the name of the image file
containing the CSMIM2's software. The command syntax is:
image [–d | filename]
The filename argument permits up to 100 characters. To return the image
name to its default, enter a pair of double-quote characters (""). The
default image name is oper.56.enet. The image command display looks
like this:
monitor:: image
Enter Image name: [(ip) "oper.56.enet", (mop)
"OPER_56_ENET.SYS"]::
Enter TFTP Load Directory [""]::
Enter TFTP Dump path/filename ["dump.192.9.200.88"]::
3-14
16K->|Data 0xff
16K->|Data 0x0
CSMIM2 Installation Guide