Cabletron Systems CSMIM2-16 Installation Manual page 58

Chapter 3: ROM Monitor Commands
Prompt
Enter the number of
stop bits
Enter the parity
The slip command automatically sets the number of data bits to 8 for all
SLIP interfaces. The number of data bits does not include the start, stop,
or parity bits. The slip command display looks like this:
monitor:: slip
Line number (1-16):: 6
Allow SL/IP on this port? (y/n) [n]:: y
Enter local endpoint address [0.0.0.0]:: 192.9.200.214
Local endpoint address: 192.9.200.214
Enter subnet mask [255.255.255.0]::
Constructed new subnet mask.
Enter remote endpoint address [0.0.0.0.]:: 192.9.200.0
Remote endpoint address: 192.9.200.0
Enter remote load/dump host address [default 192.9.200.88]::
Using remote endpoint address: 192.9.200.88
Should this interface be used for memory dumps? (y/n) [y]::
Enter the baud rate [9600]::
Enter the number of stop bits (1,1.5,2) [1]::
Enter the parity (none,even,odd) [none]::
Pressing CONTROL + C interrupts the slip command; the
NOTE
parameters remain unchanged until the command completes
normally.
3-24
Table 3-2 The slip Command Prompts
Description
Pressing the RETURN key accepts the default
(one). Generally, SLIP implementations require
the default.
Pressing the RETURN key accepts the default
(none). Generally, SLIP implementations require
the default.
CSMIM2 Installation Guide