Cabletron Systems CSMIM2-16 Installation Manual page 36

Chapter 3: ROM Monitor Commands
addr [-d]
boot [-v] [<file>]
boot [-l] [<file>]
config
console-baud
erase
help (or "?")
image [-d/<file>]
ipx [-d]
lat_key [-d]
mop [-d]
net
option_key [-d]
ping
ports [-d]
sequence
[-d | <list>]
slip [-d] <port>
stats [-slip]
3-2
Table 3-1 ROM Monitor Command
Displays and sets EEPROM values relevant to network
addressing, including the CSMIM2's Internet address.
Manually boots and loads the CSMIM2's operating
code.
Erases the existing Flash memory and copies a new
image to Flash.
Displays the current hardware configuration and
revision levels.
Changes the console port's baud rate.
Erases non-volatile memory.
Display the list of ROM Monitor commands.
Displays and/or sets the load image and TFTP load
dump names.
Sets IPX load/dump file server.
Sets LAT key.
Sets MOP load/dump address.
Executes an Ethernet stand-alone external loopback
test.
Sets or displays the option key.
Sends ICMP ECHO_REQUEST, host [data size]
[npackets].
Shows the current status of all ports and tests specified
port(s).
Displays and edits the load/dump interface list.
Configures an SL/IP interface.
Displays current network statistics gathered by the
ROM.
CSMIM2 Installation Guide