Erase - Cabletron Systems CSMIM2-16 Installation Manual

3. From the remote site:
• Dial into the modem connected to the CSMIM2.
• Type RETURN until the monitor prompt appears.
3.2.5

erase

The erase command erases the contents of non-volatile memory,
including the CSMIM2's IP address. This command also restores the
parameters to their factory defaults. The syntax is:
erase
If the self-boot option is installed, the erase command prompts for which
non-volatile memory to erase: EEPROM or FLASH. Entering 1 at the
prompt causes the CSMIM2 to erase the EEPROM memory
(configuration information); entering 2 at the prompt causes the CSMIM2
to erase the Flash memory (self-boot image).
The erase command display looks like this:
monitor:: erase
1) EEPROM (i.e. configuration information)
2) FLASH (i.e. self boot image)
Enter 1 or 2 :: 1
Erase all non-volatile EEPROM memory? (y/n) [n]:: y
Erasing <16352 or 8160 bytes> of non-volatile memory.
Please wait . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Initialized checksum record installed
.
.
.
CSMIM2 Installation Guide
Commands
16K->|Data 0xff
16K->|Data 0x0
3-13