Chapter 2 Installing The Csmim2; General; Unpacking The Csmim2 - Cabletron Systems CSMIM2-16 Installation Manual

2.1

GENERAL

This chapter details the installation and set up procedures for the
CSMIM2 family. Unless otherwise specified, the term CSMIM2 is used to
signify all members of the CSMIM2 family including the MODMIM-4
with its various upgrade options. See appendices for installation
procedures for DVRAM, Flash, and board upgrades.
2.2

UNPACKING THE CSMIM2

Unpack the CSMIM2 as follows:
Observe all antistatic precautions when handling sensitive
!
electronic equipment.
CAUTION
1. Remove the shipping material covering the CSMIM2.
2. Carefully remove the module from the shipping box. Leave the
module in its non-conductive bag until you are ready to install it.
3. Visually inspect the non-conductive bag. If there are any signs of
damage, contact Cabletron Systems Technical Support immediately.
4. Place the static grounding strap properly on your wrist before opening
the non-conductive bag.
5. Open the non-conductive bag by tearing the black and yellow tape
seal.
Do not cut the bag open, as damage to the CSMIM2 may
!
result.
CAUTION
6. Perform a second visual inspection of the module.
CSMIM2 Installation Guide
CHAPTER 2
INSTALLING THE CSMIM2
2-1