Mop; Net - Cabletron Systems CSMIM2-16 Installation Manual

3.2.10 mop

The mop command sets the MOP load/dump address. This is useful when
the loading the CSMIM2's operational image from a VAX VMS load
host. The command syntax is:
mop [–d]
The mop command display looks like this:
monitor:: mop
Enter preferred MOP load/dump address [<uninitialized>]::
Load Broadcast Y/N [Y]::
The command displays the current MOP settings:
mop –d
monitor:: mop -d
MOP preferred load/dump address <uninitialized>
Load Broadcast: Y

3.2.11 net

The net command executes an Ethernet transceiver loopback test on the
local area network. The command syntax is:
net
The net command display looks like this:
monitor:: net
Network test – PASSED
This transciever loopback test sends out a short test packet from the
CSMIM2 through the MMAC backplane to test the integrity of the
network. One of the Ethernet backplane channel connections must be
active and valid for this test to pass.
CSMIM2 Installation Guide
Commands
3-17