Setup Switch - Cabletron Systems CSMIM2-16 Installation Manual

Chapter 1: Introduction
Figure 1-1 CSMIM2-16 front panel
1.5.7

SETUP Switch

The SETUP button allows you to change the operational mode of the
CSMIM2 from Normal to Test. It also functions as a Reset button (see
Note below). The CSMIM2 automatically powers up in normal mode. To
enter test mode, press the SETUP button within three seconds of
powering-up.
Additionally, a Setup signal is provided from the MicroMMAC
motherboard. When this signal is active, it will perform a cold start of the
CSMIM2.
1-6 CSMIM2 Installation Guide