3.
From the remote site:
•
Dial into the modem connected to the Micro-CS.
•
Type RETURN until the monitor prompt appears.
3.2.5
erase
The erase command erases the contents of non-volatile memory,
including the Micro-CS's IP address. This command also restores the
parameters to their factory defaults. The syntax is:
erase
If the self-boot option is installed, the erase command prompts for which
non-volatile memory to erase: EEPROM or FLASH. Entering 1 at the
prompt causes the Micro-CS to erase the EEPROM memory
(configuration information); entering 2 at the prompt causes the
Micro-CS to erase the Flash memory (self-boot image).
The erase command display looks like this:
monitor:: erase
1) EEPROM (i.e. configuration information)
2) FLASH (i.e. self boot image)
Enter 1 or 2 :: 1
Erase all non-volatile EEPROM memory? (y/n) [n]:: y
Erasing <16352 or 8160 bytes> of non-volatile memory.
Please wait . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Initialized checksum record installed
.
.
.
Micro-CS Installation Guide
Commands
16K->|Data 0xff
16K->|Data 0x0
3-13