Table of Contents
Advertisement
Appendix C: Flash Upgrade Instructions
C.4
INSTALLATION PROCEDURE
Observe all anti-static procedures when handling electronic
!
equipment.
CAUTION
C.4.1
Installing the Flash Daughter Card
1.
Install the two (2) snap-in nylon standoffs through the holes in each
corner of the flash daughter card.
2.
Align the connector of the flash daughter card with the J12 connector
on the Micro-CS (see Figure C-1) and seat firmly ensuring that the
nylon standoffs snap into their mating holes on the board.
Please note that although the hardware configuration of the FLASH card
is the same for the Micro-CS, CSMIM2, and MODMIM, the image is not.
The Micro-CS uses "oper.52.enet" and the CSMIM2/MODMIM use
"oper.42.enet". It is possible to use the FLASH card on either platform,
but the image loaded must be the correct one for the application.
C-2
Nylon standoffs
Snap In Retainer
J12
Figure C-1 Flash Card Installation
FLASH CARD
Micro-CS Installation Guide
Advertisement
Table of Contents
