Changing The Engine Oil And Filter - Toro 30839 Operator's Manual

Figure 46
1. Primary filter
5. Inspect the new filter for shipping damage, checking
the sealing end of the filter and the body. Do not
use a damaged element.
6. Insert the new filter by applying pressure to the outer
rim of the element to seat it in the canister. Do not
apply pressure to the flexible center of the filter.
7. Clean the dirt ejection port located in the removable
cover. Remove the rubber outlet valve from the
cover, clean the cavity and replace the outlet valve.
8. Install the cover orienting the rubber outlet valve in
a downward position—between approximately 5:00
to 7:00 when viewed from the end.
9. Secure the cover latches.
Changing the Engine Oil and
Filter
Service Interval: After the first 50 hours
Every 150 hours
1. Remove either drain plug (Figure 47) and let oil flow
into a drain pan. When the oil stops flowing, install
the drain plug.
1. Engine oil drain plug
2. Remove the oil filter (Figure 48). Apply a light coat
of clean oil to the new filter seal before screwing it
on. Do not overtighten.
1. Engine oil filter
3. Add oil to the crankcase; refer to Checking the
Engine Oil Level.
39
Figure 47
Figure 48