Servicing The Air Filter; Changing The Engine Oil; Changing The Engine-Oil Filter - Toro 22285 Operator's Manual

53cm heavy-duty recycler/rear bagger lawn mower
Hide thumbs Also See for 22285:
Table of Contents

Advertisement

personal injury. Run the engine dry or remove the
fuel with a hand pump; never siphon the fuel.
To ensure optimum performance of the machine,
use only genuine Toro replacement parts and
accessories. Replacement parts and accessories
made by other manufacturers could be dangerous,
and such use could void the product warranty.

Servicing the Air Filter

Service Interval: Every 25 hours—Clean the foam
pre-filter (more frequently in dusty
conditions).
Every 300 hours—Replace the paper air filter
(more frequently in dusty conditions).
Important:
Do not operate the engine without the
air filter assembly in place; otherwise, extreme
engine damage will occur.
1.
Shut off the engine and wait for all moving parts
to stop.
2.
Disconnect the wire from the spark plug.
3.
Remove the cover and clean it thoroughly
(Figure
24).
1. Cover
2. Foam pre-filter and paper
air filter
4.
Remove and the foam pre-filter and the paper-air
filter from the air-filter base
5.
Remove the foam pre-filter from the paper air
filter, and wash the foam pre-filter with a mild
detergent and water, then blot it dry.
6.
Inspect the paper air filter, and replace it if it is
excessively dirty.
Important:
Do not try to clean a paper filter.
Figure 24
3. Air-filter base
(Figure
24).
7.
Install the foam pre-filter onto the paper air filter.
8.
Install the foam pre-filter and paper air filter onto
the air-filter base.
9.
Install the cover.

Changing the Engine Oil

Service Interval: After the first 8 hours
Every 50 hours
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
*There is residual oil in the crankcase after you drain
the oil. Do not pour the entire capacity of oil into the
crankcase. Fill the crankcase with oil as directed in
the following steps.
1.
Shut off the engine and wait for all moving parts
to stop.
2.
Disconnect the wire from the spark plug.
3.
Drain the fuel from the fuel tank.
4.
Place a suitable drain pan under the dipstick/oil
drain.
5.
Clean around the dipstick.
6.
Remove the dipstick by rotating the cap
counterclockwise and pulling it out.
7.
Tip the machine onto its right side (air filter up)
to drain the oil into the drain pan.
8.
After draining the oil, return the machine to the
g005347
operating position.
9.
Fill the crankcase to the correct level on the
dipstick with fresh oil; refer to
the Engine (page
10.
Insert the dipstick into the filler neck and rotate
the cap clockwise until it is tight.
Changing the Engine-Oil
Filter
Service Interval: Every 200 hours
1.
Run the engine to warm the oil.
23
0.65 L (22 fl oz)* without oil
filter; 0.85 L (29 fl oz)* with oil
filter
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
5 Adding Oil to
10).

Advertisement

Table of Contents
loading

Table of Contents