Installing The Dimm - Enterasys Matrix 7GR4202-30 Hardware Installation Manual

Memory Locations and Replacement Procedures
Figure B-10
1 Connector arms
3. Rotate the DIMM upwards, then remove it from the connector fingers.

Installing the DIMM

To install a DIMM, refer to Figure
1. Insert the DIMM down between the connector fingers.
2. Pivot the DIMM downward so the tabs on the connector arms align with the two DIMM
alignment notches. With the two connector arms spread outward, push the DIMM down
between the connector arms. Then release the two connector arms to lock the DIMM into
place.
3. If necessary, reinstall the NEM. Refer to the installation instructions shipped with the NEM for
details.
Figure B-11
1 DIMM
2 Connector fingers
B-8 Mode Switch Settings and Installing Options
Removing the Existing DIMM
À
2 DIMM
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.
Installing the DIMM
Â
Â
B‐11 and proceed as follows:
Ã
À
Á
3 Connector arms
4 DIMM alignment notches (2)
Á
À
3 Connector fingers
Ã
Â