Xenpak Module Installation; Removing A Xenpak Module - Enterasys Matrix 7GR4202-30 Hardware Installation Manual

Figure 3-4

XENPAK Module Installation

1 XENPAK module (10GBASE-LR is shown)
2 XENPAK module, Top Side
3 Edge connector (insertion side)

Removing a XENPAK Module

Caution: The XENPAK module and 7KR4290-02 are sensitive to static discharges. Use an
antistatic wrist strap and observe all static precautions during this procedure. Failure to do so can
result in damage to the XENPAK module and 7KR4290-02. Always leave the XENPAK module in
the antistatic bag or an equivalent antistatic container when not installed.
Precaución: Si lo hace, puede dañar el XENPAK ni el módulo 7KR4290-02, puesto que es muy
sensible a las descargas de electricidad estática, al igual que el dispositivo host. Utilice la pulsera
antiestática y tome todas las precauciones necesarias durante este procedimiento. Si no lo hace,
pude dañar el XENPAK ni el módulo 7KR4290-02 o el dispositivo host. Mientras no esté instalado,
mantenga el XENPAK en su bolsa antiestática o en cualquier otro recipiente antiestático.
To remove a XENPAK module from the 7KR4290‐02, refer back to Figure
follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the XENPAK module.
2. Remove any network cable (not shown) connected to the SC connector on the XENPAK
module. To remove an SC cable connector from theXENPAK module interface port, carefully
pull the connector out of the port. It may need to be loosened by gently moving it from side to
side to release the latching keys. For more information about an SC cable connection, refer to
"Connecting to the Network" on page 3‐13.
3. Turn the thumbscrews counterclockwise to release the XENPAK module from the 7KR4290‐02
front panel.
4. Grasp the thumbscrews and pull the XENPAK module straight out of the 7KR4290‐02 port
slot.
5. Before storing or shipping the XENPAK module, insert it into a static‐free container. This
completes the removal procedure.
Installing an Optional XENPAK Module
4 Module port slot
5 Thumbscrews
3‐4 and proceed as
Matrix DFE-Diamond Series Installation Guide 3-7