Dimm Replacement Procedure; Installing The Dimm - Enterasys Platinum Distributed Forwarding Engine 7G4205-72 Hardware Installation Manual

Dfe-platinum series

Hide thumbs Also See for Enterasys Platinum Distributed Forwarding Engine 7G4205-72:

Table of Contents

Gaining Access to Memory Modules

Reinstall the safety cover. Refer to "Reinstalling the Safety Cover" on page B‐14 for

instructions.

Figure B-6

1 Connector arms

2 DIMM

DIMM Replacement Procedure

In the event that the DIMM needs to be replaced, the following sections explain how to

remove and install the SIMM. If you have questions concerning the replacement of the

SIMM, refer to "Getting Help" on page xviii for details on how to contact

Enterasys Networks.

Removing the DIMM

To remove the existing DIMM, proceed as follows:

Remove and save the seven screws attaching the safety cover to the standoffs on the

main PC board.

Locate the DIMM connector on the main PC board. Refer back to Figure

DIMM location on the 7G4285‐49.

B-10 Mode Switch Settings and Option Installations

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive

electronic equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones

de seguridad para evitar descargas de electricidad estática.

3 Connector fingers

4 DIMM alignment notches (2)

B‐2 for the

Table of Contents

Dfe-platinum 7g4285-49 Dfe-platinum 7g4205-72