How To Use This Guide; Related Documents - Enterasys Matrix 7GR4202-30 Hardware Installation Manual

How to Use This Guide

How to Use This Guide
This preface provides an overview of this guide and the DFE‐Diamond Series manual set, and a
brief summary of each chapter; defines the conventions used in this document; and instructs how
to obtain technical support from Enterasys Networks. To locate information about various subjects
in this guide, refer to the following table:
For...
An overview of the DFE-Diamond modules
Network requirements that must be met before
installing the DFE modules
Instructions to install the DFE module hardware, and
optional Mini-GBICs and XENPAK interface modules
Troubleshooting installation problems and diagnosing
network/operational problems using the LANVIEW
LEDs
Specifications, environmental requirements, and
physical properties of the DFE modules, Mini-GBIC
interface cards, and XENPAK interface modules
Instructions to set the mode switches when necessary
and to remove and replace DIMM and DRAM SIMM
memory

Related Documents

The manuals listed below can be obtained from the World Wide Web in Adobe Acrobat Portable
Document Format (PDF) at the following site:
http://www.enterasys.com/support/manuals
• Enterasys Matrix DFE‐Diamond/Platinum Series Configuration Guide provides information on
how to use the Command Line Interface to set up and manage the DFE modules.
• Enterasys Matrix Network Expansion Module Hardware Installation Guide provides instructions to
install the Enterasys Matrix Network Expansion Modules (NEMs) and Mini‐GBICs.
• Cabling Guide provides information on dB loss and cable specifications.
Unlike the Enterasys Matrix DFE‐Diamond/Platinum Series Configuration Guide, the Cabling
Guide is not listed alphabetically on the web site. Instead, it is listed under the Overview Guides
link.
xiv About This Guide
Refer to...
Chapter 1, Introduction
Chapter 2, Network Requirements
Chapter 3, Installation
Chapter 4, Troubleshooting
Appendix A, Specifications
Appendix B, Mode Switch Settings and
Installing Options