Enterasys Matrix 7GR4202-30 Hardware Installation Manual page 61

Table 4-1 LANVIEW LEDs (continued)
LED Color
CPU None
Amber
Green
Red
Green
and
Amber
Amber
and off
RX None
(Receive)
Green
Amber
RX Red
TX None
(Transmit)
Green
Red
State
Power off.
Blinking. Module in process
of booting.
Solid. Testing.
Blinking. Image starts
running.
Solid. Functional.
Solid. Processor in reset.
Blinking. Indicates that the
DFE module is in the
process of shutting down.
Alternate (67% on, 33%
off). Indicates that a
shutdown process has
completed. This indication
will remain for 60 seconds
before automatically
restarting.
No link. No activity. Port
enabled or disabled.
Solid. Link present, port
enabled, no traffic is being
received by the interface.
Flashing. Link present, port
enabled, traffic is being
received by the interface.
Blinking. Indicates
collisions. This indication is
only supported on 10/100
ports.
Port enabled, but no activity.
Flashing. Indicates data
transmission activity. Rate of
flashing indicates the data
rate.
Flashing. Fault or Error
(collision).
Recommended Action
Ensure chassis has adequate power.
None.
If the LED remains amber for several minutes,
contact Enterasys Networks for technical
support.
None.
None.
None.
None. This state is activated when the RESET
button is pressed for less than 1 second to a
start the process of an orderly shutdown.
While in this state, do not remove any DFE
module.
While in this state, you have 60 seconds to
safely remove the DFE module from the
chassis.
None.
None.
None.
Contact Enterasys Networks for technical
support.
If it is known that the port should be active and is
not, contact Enterasys Networks for technical
support.
None.
None, unless there is a high rate of activity. In
this case, check for network configuration
problems or a defective device.
Matrix DFE-Diamond Series Installation Guide 4-3
Using LANVIEW