Nem Removal And Dram Simm Connector Location 7H4382-49 Or 7H4383-49 - Enterasys Matrix 7G4270-12 Hardware Installation Manual

a. Remove and save the two screws attaching the NEM to the front panel.
b. Lift the NEM straight up and off the two module connectors on the main PC board.
Figure B-7 NEM Removal and DRAM SIMM Connector Location 7H4382-49 or 7H4383-49
1 NEM (not on all DFE modules)
2 Main PC board (7H4382-49 is shown)
3 Screws
2. Refer to Figure B-8. Push the connector arms away from the memory module to release it from
the connector.
Note: The ejector arms on this connector are not spring loaded, so they will remain in
the open position until manually closed.
3. Remove the module from the connector.
Memory Locations and Replacement Procedures
➃
➂
4 DFE module front panel
5 Module connectors on main board
6 DRAM SIMM memory module
Mode Switch Bank Settings and Optional Installations
➄
➁
➅
➀
B-7