Lanview Leds - Enterasys Matrix 7G4270-12 Hardware Installation Manual

Using LANVIEW
(Groups 1 through 4). Each time the GROUP SELECT button is pressed, the GROUP LED lights
up in sequence, indicating which group is selected. The receive and transmit activity for that group
of segments is then indicated by the RX and TX LEDs for each port.
Figure 4-1 LANVIEW LEDs
1 MGMT LED
Table 4-1 describes the LED indications and provides recommended actions as appropriate.
NOTE: The terms used in
Flashing indicates an LED is flashing randomly.
Blinking indicates an LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid indicates a steady LED light. No pulsing.
Alternating indicates an LED is flashing in a steady rate other than 50% on, 50% off.
4-2 Troubleshooting
À
2 Group 1, Port 1 LEDs
Table 4-1 indicate the following:
Á