Enterasys Matrix 7G4270-12 Hardware Installation Manual page 48

Installing Module into Matrix E7 or N7 Chassis
Installation
To install the module, refer to
Caution: To prevent damaging the backplane connectors in the following step, take
care that the module slides in straight and properly engages the backplane connectors.
Ensure that the top lever lines up with the desired slot number located on the front panel
of the chassis. Refer to
Precaución: Para evitar que se dañen los conectores del panel posterior en el siguiente
paso, intente deslizar el módulo en forma recta y verifique que se enganche
correctamente en los conectores de panel posterior.
Asegúrese de que la palanca superior esté alineada con respecto al número de ranura
correspondiente ubicado en el panel frontal del chasis. Consulte en
1. Locate the chassis card guides that line up with the slot number in which the module
installed. Make sure the module locking levers are in the open position (top and bottom).
2. Align the module card between the upper and lower card guides of the desired slot and slide it
into the chassis, taking care that the module slides in straight. See Caution below.
Caution: Due to the amount of force needed to properly seat the module connectors
into the backplane connectors, it is best to apply force to the end of the levers to insert
(or eject) the module. Otherwise, damage could result to the module and chassis.
Precaución: Para colocar los conectores del módulo en los conectores del panel
posterior correctamente es necesario hacer bastante fuerza, por ello, para insertar o
quitar el módulo, se recomienda concentrar la fuerza en el extremo de las palancas. Si
no lo hace, podría dañar el módulo y el chasis.
3. Slide the module into the slot until you can engage the top and bottom locking levers with the
chassis as shown in
Caution: In step 4, do not force the locking levers to the point that they touch the face of
the front panel. Forcing the locking levers to this point could damage the module and
chassis.
Precaución: En el paso 4, tenga cuidado de no llevar las palancas de cierre a un punto
en donde estén en contacto con el panel frontal. Si lo hace, podría dañar el módulo y/o
el chasis.
4. Refer to the Caution note above, then rotate the two levers into the closed position .
5. If the chassis in which the module is installed was powered down for the installation, turn the
power supplies on. Check to see that the module CPU LED settles at solid green after a few
minutes. If the LED does not turn solid green, refer to
3-12 Installation
Figure 3-5 and proceed as follows:
Figure 3-5.
Figure 3-5.
Chapter 4 for troubleshooting details.
Figure 3-5.
➂
will be