Dimm Replacement Procedure (All Dfe Modules - Enterasys Matrix 7G4270-12 Hardware Installation Manual

Memory Locations and Replacement Procedures
B.3.2

DIMM Replacement Procedure (All DFE Modules)

To access and remove a DIMM, you may need to remove the optional
Note:
expansion module (NEM)
back to the instructions in the section,
7H4383-49)
In the event that the Dual In-line Memory Module (DIMM) needs to be replaced, the following
sections explain how to remove and install the DIMM. If you have questions concerning the
replacement of the DIMM, refer to
Enterasys Networks.
Removing the DIMM
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling
sensitive electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las
precauciones de seguridad para evitar descargas de electricidad estática.
To remove the existing DIMM, proceed as follows:
1. Locate the DIMM connector on the main PC board. Refer back to
location on either the 7H4382-49 or 7H4383-49. Refer back to
7G4270-12, 7G4202-30, or 7H4203-72.
2. Push the connector arms away from the DIMM, as shown in
lift the DIMM enough to release it from the connector fingers.
B-12 Mode Switch Bank Settings and Optional Installations
, if one is installed in your
" on page B-6
"Getting
DFE module
"DRAM SIMM Replacement Procedure (for 7H4382-49 and
Help" on page xxii for details on how to contact
network
. To remove the
Figure B-5 for the DIMM
Figure B-6 for the location on the
Figure B-12, and simultaneously
, refer
NEM