About This Guide; Who Should Use This Guide - Enterasys Matrix 7G4270-12 Hardware Installation Manual

This guide provides an overview, installation and troubleshooting instructions, and specifications
for the Enterasys Matrix
7G4203-72 modules, and the Mini-GBIC modules.
For information about the CLI (Command Line Interface) set of commands used to configure and
manage the DFE modules, refer to the Enterasys Matrix DFE-Platinum Series Configuration
Guide.
Note: In this guide, the following terms are used:
•
DFE refers to Distributed Forwarding Engine series of modules.
•
DFE module or module refers to the 7H4382-49
7G4202-30
module is referred to by its model number (such as 7H4382-49).
•
Network Expansion Module or NEM refers to an optional uplink card installed on the
main logic board and accessible through the option slot of the 7H4382-49 or
7H4383-49.
•
Mini-GBIC (Mini-Gigabit Interface Card) refers to a smaller optional interface card that
plugs into a NEM (network expansion module) or the 7G4270-12 port slots.

WHO SHOULD USE THIS GUIDE

Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
This guide is intended for a network administrator responsible for installing and setting up the
DFE modules.
®
DFE-Platinum 7H4382-49, 7H4383-49, 7G4270-12, 7G4202-30,
,
or 7G4203-72. If the information applies only to one of the modules, the

About This Guide

, ,
7H4383-49 7G4270-12
About This Guide
,
xix