Connecting A Twisted Pair Segment Using Rj21 Straight Connector - Enterasys Matrix 7G4270-12 Hardware Installation Manual

Figure 3-12 Connecting a Twisted Pair Segment Using RJ21 Straight Connector
1
RJ21 straight connector
2
RJ21 port connector
3. To install an RJ21 right-angle connector, refer to
a. If using an optional RJ21 angle adapter available from Enterasys Networks, insert the angle
adapter into the RJ21 port connector.
b. Tighten the two screws to secure the RJ21 angle adapter to the RJ21 port connector.
c. Insert the RJ21 right-angled connector
clips snap into place. As shown in
be positioned along the front of the device when using a right-angle RJ21 connector.
Note: The cable pinouts for a 25-pair cable (RJ21) can be found in the Cabling Guide.
Refer to "Related
document.
d. Proceed to step
Â
À
Documents" in About This Guide for details on how to obtain this
4.
Á
Â
Retaining screws
3
GROUP SELECT button
4
Figure 3-13
➃
into the RJ21 angle adapter until the two retaining
Figure 3-14, the RJ21 angle adapter allows the cables to
Connecting to the Network
Ã
and proceed as follows:
Installation 3-21