Enterasys Matrix 7G4270-12 Hardware Installation Manual page 42

Dfe-platinum series
Hide thumbs Also See for Matrix 7G4270-12:
Table of Contents

Advertisement

Installing an Optional Mini-GBIC
Removing the Mini-GBIC
Caution: Do NOT remove a Mini-GBIC from a slot without releasing the locking tab
located under the front bottom end of the Mini-GBIC
The Mini-GBIC and its host device are sensitive to static discharges. Use an antistatic
wrist strap and observe all static precautions during this procedure. Failure to do so
could result in damaging the Mini-GBIC or host device. Always leave the Mini-GBIC in
the antistatic bag or an equivalent antistatic container when not installed.
Precaución: NO quite el Mini- GBIC de la ranura sin antes abrir la traba ubicada en la
parte frontal del Mini- GBIC.
Si lo hace, puede dañar el Mini- GBIC, puesto que es muy sensible a las descargas de
electricidad estática, al igual que el dispositivo host. Utilice la pulsera antiestática y
tome todas las precauciones necesarias durante este procedimiento. Si no lo hace,
pude dañar el Mini- GBIC o el dispositivo host. Mientras no esté instalado, mantenga el
Mini- GBIC en su bolsa antiestática o en cualquier otro recipiente antiestático.
To remove a Mini-GBIC from a port slot, proceed as follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the Mini-GBIC.
2. Remove the cables connected to the Mini-GBIC.
3. Release the Mini-GBIC from the port slot. Refer back to the appropriate figure listed below to
locate the release mechanism and proceed as instructed.
-
For the type of Mini-GBIC shown in
to release the Mini-GBIC.
-
For the type of Mini-GBIC shown in
Mini-GBIC.
-
For the type of Mini-GBIC shown in
Mini-GBIC.
4. Grasp the sides of the Mini-GBIC and pull it straight out of the port slot.
If storing or shipping the Mini-GBIC, insert its dust protector to protect its fiber-optic ports.
3-6
Installation
.
Figure
3-1, push in on the release tab as far as it will go
Figure
3-2, pull out on the release tab to release the
Figure
3-3, pull down on the wire handle to release the
This can damage the Mini-GBIC.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents