Completing The Installation; Completing The Installation Of A New System - Enterasys Matrix 7G4270-12 Hardware Installation Manual

Completing the Installation

RJ45
Pin
1
2
4
5
6
8
3.9 COMPLETING THE INSTALLATION
Completing the DFE module installation depends on if the module is being installed in:
•
a new DFE module system (refer to
•
an established, operating DFE module system (refer to
3.9.1

Completing the Installation of a New System

In a new system of DFE modules, one of the installed DFE modules will become the management
module on chassis power up, and all DFE modules will automatically be set to the factory default
values. A complete list of the factory default values are provided in Chapter 3 of the Enterasys
Matrix DFE-Platinum Series Configuration Guide.
After installing all DFE modules into the host chassis and making the connections to the network,
proceed to the following
the module management startup screen from your PC, terminal, or modem connection.
3-34 Installation
Modem Port Adapter Wiring and Signal Diagram
Conductor
Blue
Orange
Red
Green
Yellow
Gray
Section
First-Time Log-In Using a Console Port Connection
DB25
Pin Signal
2 Transmit (TX)
8 Data Carrier Detect (DCD)
3 Receive
7 Ground (GRD)
20 Data Terminal Ready (DTR)
22 Ring Indicator
3.9.1), or
Section 3.9.2).
procedure to access