Enterasys Matrix 7G4270-12 Hardware Installation Manual page 101

Figure B-9 Installing the DRAM SIMM on 7H4382-49
1 Connector arms
2 DRAM SIMM memory module
Removing the DRAM SIMM from 7G4270-12, 7G4202-30, or 7H4203-72
Caution: Observe all antistatic precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las
precauciones de seguridad para evitar descargas de electricidad estática.
To remove the existing DRAM SIMM, proceed as follows:
1. Locate the DRAM SIMM connector on the main PC board. Refer back to
2. Push the connector arms away from the DRAM SIMM, as shown in
release the DRAM SIMM from the connector contacts.
Memory Locations and Replacement Procedures
Ã
À
Â
3 Connector fingers
4 DRAM SIMM alignment notches (2)
Mode Switch Bank Settings and Optional Installations
or
7H4383-49
Á
Ã
À
Figure
Figure B-6.
B-10, enough to
B-9