Enterasys Matrix 7G4270-12 Hardware Installation Manual page 73

Logging in with an Administratively-Configured User Account
If the device's default user account settings have been changed, proceed as follows:
1. At the login prompt, enter your administratively-assigned user name and press ENTER.
2. At the Password prompt, enter your password and press ENTER.
The notice of authorization and the Matrix prompt displays as shown back in
Note: Users with Read-Write (rw) and Read-Only access can use the set password
command to change their own passwords. Administrators with Super User (su) access
can use the set system login command to create and change user accounts, and the
set password command to change any local account password. For information on the
set password and set system login commands, refer to Chapter 3 in the Enterasys
Matrix DFE-Platinum Series Configuration Guide
The DFE module is now ready to be configured. For information about setting the IP address and
configuring Telnet settings for remote access to DFE management, refer to Chapter 3 in the
Enterasys Matrix DFE-Platinum Series Configuration Guide. The CLI commands enable you to
initially set up and perform more involved management configurations.
The Enterasys Matrix DFE-Platinum Series Configuration Guide is available online at:
http://www.enterasys.com/support/manuals
If you require assistance, contact Enterasys Networks using one of the methods described in
"Getting Help" on page xxii.
Completing the Installation
Figure
.
3-20.
Installation 3-37