Connecting To A Modem - Enterasys Matrix 7G4270-12 Hardware Installation Manual

Connecting to COM Port for Local Management
3. Connect the RJ45-to-DB25 adapter to the communications port on the modem .
4. Turn on the modem .
5. With a PC connected to a remote modem
accomplish this, you must configure your PC VT emulation package with the following
parameters.
6. When these parameters are set, the Local Management password screen will display. Refer to
the Enterasys Matrix DFE-Platinum Series Configuration Guide for further information.
Figure 3-19 Connecting to a Modem
1 UTP cable with RJ45 connectors
2 RJ45 COM port
3 RJ45-to-DB25 modem adapter
3-32 Installation
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Ä
➄
, you can configure the switch remotely. To
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
à Â
4 Local modem
5 Remote modem
À Á