Enterasys Matrix 7G4270-12 Hardware Installation Manual page 102

Memory Locations and Replacement Procedures
Figure B-10 Removing Existing DRAM SIMM from 7G4270-12
1
Connector arms
3. Pull the DRAM SIMM straight up and remove it from the connector contacts.
Installing the DRAM SIMM on 7G4270-12
Caution: Observe all antistatic precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las
precauciones de seguridad para evitar descargas de electricidad estática.
To install a DRAM SIMM, refer to
1. Push the connector arms away from the DRAM SIMM enough to insert the DRAM SIMM into
the connector contacts.
2. Insert the DRAM SIMM straight down between the connector contacts enough for the tabs on
the connector arms to align with the two DRAM SIMM alignment notches.
3. Push the DRAM SIMM down into the connector contacts. Then rotate the two connector arms
toward the DRAM SIMM to lock it into place.
B-10 Mode Switch Bank Settings and Optional Installations
À
2
DRAM SIMM
Figure B-11
Á
Â
3
7G4202-30
,
and proceed as follows:
, , or
7G4202-30 7H4203-72
À
Connector contacts
7H4203-72
, or