Table of Contents
Advertisement
This chapter contains instructions for the following tasks:
•
Unpacking the VHSIM2-A6DP
•
Installing APIMs
•
Installing a VHSIM2-A6DP
To install the VHSIM2-A6DP and APIMs, the following tools are required:
•
Antistatic wrist strap (provided with the 6C105 chassis or standalone device)
•
Phillips screwdriver
2.1
UNPACKING THE VHSIM2-A6DP
Unpack the VHSIM2-A6DP as follows:
CAUTION: The VHSIM2-A6DP and the host module or device are sensitive to static
discharges. Use an antistatic wrist strap and observe all static precautions during this
procedure. Failure to do so could result in damage to the VHSIM2-A6DP, the host
module, or device.
1. Remove the shipping box material covering the VHSIM2-A6DP.
2. Carefully remove the module from the shipping box. Leave the module in its non-conductive
bag until you are ready to install the module.
3. Attach the antistatic wrist strap (refer to the instructions on the antistatic wrist strap package).
4. After removing the module from its non-conductive bag, visually inspect the device. If you
notice any signs of damage, contact Enterasys Networks immediately. Refer to
(Section
(Section
2.2)
(Section
2.1)
2.4)
Installation
Section
1.2.
Installation
2
2-1
Advertisement
Table of Contents
