Table of Contents
Advertisement
<Configuration Example>
Overview: Enable the SNMP function, then set the SNMP group and
the SNMP user.
(1) Enable the SNMP agent.
(2) Set the SNMP group as below.
group name : test, Read/Notify : CommunityView
(3) Set the SNMP user as below.
user name : test, group : test, authentication MD5, password
panasonic
(4) Set the SNMP trap receiver settings as below.
trap receiver 1, SNMP v3, 192.168.1.200, user : test
M24eGi> enable
M24eGi# configure
(1)
M24eGi(config)# snmp-server agent
(2)
M24eGi(config)# snmp-server group test v3
M24eGi(config-snmp-group)# read CommunityView
M24eGi(config-snmp-group)# notify CommunityView
M24eGi(config-snmp-group)# security-level auth_nopriv
M24eGi(config-snmp-group)# exit
(3)
M24eGi(config)# snmp-server user 1 test
NOTICE: Must set Auth. if the user group is an auth_nopriv group;
Must set both Auth. and Priv. if the user group is an auth_priv group
M24eGi(config-snmp-user)# group test
M24eGi(config-snmp-user)# authentication md5 panasonic
M24eGi(config-snmp-user)# exit
(4)
M24eGi(config)# snmp-server host 1 type v3 192.168.1.200 trap test
M24eGi(config)# end
M24eGi#
Fig. 3-3-2 Example of executing the command to show the SNMP information
79
Advertisement
Table of Contents
