Table of Contents
Advertisement
<Configuration Example 2>
Overview: Configure the access control to mark CoS in the VLAN
tag in order to have this Switching Hub preferentially control
packets of IP phones that support DSCP only.
(1) Configure the classifier to target packets with DSCP set to 32.
(2) Configure the in-profile to mark the target packets with a CoS
value of 6.
(3) Configure the port list to set uplink ports 22 to 24 as target
ports of the access control.
(4) Configure the out-profile to discard traffic exceeding 100 Mbps.
(5) Associate configuration items above with policy 2 and set the
policy sequence to 10.
M24eGi> enable
M24eGi# configure
(1)
M24eGi(config)# AccessControl classifier 5 dscp 32
(2)
M24eGi(config)# AccessControl inprofile 5 permit cos 6
(3)
M24eGi(config)# AccessControl outprofile 5 committed-rate 100 burst-size 5 deny
(4)
M24eGi(config)# AccessControl portlist 5 22-24
(5)
M24eGi(config)# AccessControl policy 2 portlist 5 classifier 5 policy-sequence
10 inprofile 5 outprofile 5
M24eGi(config)#
Fig. 4-4-5 Example of the access control configuration 2
234
Advertisement
Table of Contents
