Creating A Console Session Using A Modem; Stopping The Console Session; Table 14. Modem Settings - Cabletron Systems SmartStack STS16-20R Installation And User Manual

134
1200, 2400, 4800, 9600, 19200, 38400, 57600, or Autobaud. The default value for
this parameter is 9600. Make sure that your terminal emulator baud rate matches
the console baud rate you set.

Creating a Console Session Using a Modem

Use the Serial Link Configuration menu to configure the SmartStack STS16-
20D/STS16-20R in order to communicate with a console via a modem.
Set your modem according to the following table:
Caution: Some modems use slightly different names for the options. It is important
that your modem be configured correctly. The settings shown in italics are
particularly important. If your modem is not configured correctly, the connection
may cause the SmartStack STS16-20D/STS16-20R to reset.
Start the console by pressing
the console to terminate the Telnet session and press
console session.

Stopping the Console Session

Pressing
CTRL-P
returns to the greeting menu.
B
SmartStack STS16-20D/STS16-20R Token Ring Switches Installation and User Guide
Setting
Echo
Result codes
Wait for connection
Pause between calls
Drop DTR between calls
Send CR between calls
Auto baud detect
Send init if CD high
Maximum dial attempts

Table 14. Modem Settings

ENTER
returns the console session to the main menu, and pressing
Value
Off
Off
45 seconds
6 seconds
Yes
Yes
On
Yes
999
. If a Telnet session is active, press
ENTER
at
ENTER
again to start the
CTRL-
Switch Configuration