Table of Contents
Advertisement
2.4.
2.4.1.
2.4.2.
2.4.3.
20
Transportation and stocking
Conditions for transportation and stocking
Keep recommendations for the manufacturers for transportation and stocking! If the
recommendations are not kept, damage can occur to the machine.
•
Do not use a forklift truck for handling the machine, if you do not have licence for
it!
•
Do not move under suspended loads! Fault in lifting device may cause serious
injury.
•
Keep a safe distance from the machine during the transport.
Conditions for transportation and stocking:
•
Temperature of the air from -25°C to 55°C, for a short term
(max. 24 hours) temperature of the air until 70°C.
•
Do not expose the machine to radiation (for example microwave radiation, ultra-
violet radiation, laser radiation, x-ray radiation). Radiation can cause problems with
the machine function and deteriorating condition of the isolation.
•
Take measures, to prevent damage by dampness, by vibrations and by shakes.
Transport and stocking preparations
•
Close the vice and thoroughly oil all blank surfaces.
•
Lower the saw frame to the lowest position.
•
Make sure to empty the machine of all traces of the cooling agent.
•
Fasten all loose parts securely to the machine.
•
Pack and wrap the control desk securely to avoid damage during transport.
•
Fix the stickers stating the minimum approximate machine weight to at least five
well visible places.
•
The machine has to be screwed to a pallet for the transport!
Transport and stocking
Handle the machine only with the hand pallet truck or the forklift truck! If the machine
is equipped with the shackles in the pedestal, you can use the suspension cable and
the crane.
Make sure that the hand pallet truck; the forklift truck or the crane had sufficient
capacity.
Make sure that the van or the trailer had sufficient capacity.
The machine must be secured during transportation. Screw on the palette to the floor
of the van or the trailer. Be careful that the machine is not damaged during
transportation.
Store the machine only under conditions mentioned in the manual, to avoid damage of
the machine.
It is forbidden to handle the machine any other way (for example by, lifting by the saw
frame of the band saw), than it is written in this operating instructions, the machine can
be damaged!
Manual version:
1.00/ May. 2010
Manual rev.:
1
Advertisement
Table of Contents
